make your own dashboard
Your dashboard can be made by following any of the templates below. Usually constructed from MDF, cut the dash a little large and then plane and sand to fit.
To create the holes for gauges and dashboard, use a hole saw or router.
Attaching the dash can be done using brackets attached to the backside of the dashboard and tightening screws through the holes created in the dashboard.
You can take a look at this thread on The Mini Forum for ideas of your own.
To create the holes for gauges and dashboard, use a hole saw or router.
Attaching the dash can be done using brackets attached to the backside of the dashboard and tightening screws through the holes created in the dashboard.
You can take a look at this thread on The Mini Forum for ideas of your own.
Measurements
I have a PDF file with measurements for dashboards and center consoles. Unfortunately I have no idea where it came from, but if the original author comes across this, please contact me so I can give you credit.
This image was created by Scott Beavis and copied from http://www.niksula.cs.hut.fi/~mdobruck/siililand/mini/diy/alien/dash/scott/minidash.html